Leg tapers complete
Added ago
Stack of webframe parts
Added ago
Test fitting a webframe
Added ago
Webframes assembled!
Added ago
Cutting mortises in the legs
Added ago
Front and rear stretchers
Added ago
Test fitting the stretchers in the legs
Added ago
Dados cut into the side panels, a web frame goes in each
Added ago
End panel glued up
Added ago
Gluing up one half
Added ago
One side glued together
Added ago
Gluing up the remainder of the web frames to the outside end panel
Added ago
Case complete!
Added ago
Three boards glued together make the top
Added ago
These are NK (pronounced en-co) style drawers--two runners with a... more
Added ago
Trimming the runners to fit
Added ago
Fit looks good
Added ago
Started with one massive board of Sapele for the drawer fronts
Added ago
Test fitting a couple fronts
Added ago
Found some 300+ year old Douglas Fir for the drawer sides and back!
Added ago
Dovetails cut in the drawer sides, 108 altogether!
Added ago
Testing a completed drawer box, no glue yet
Added ago
Lots of clamps to glue up a drawer
Added ago
Three down, three to go
Added ago
Drawers complete! Painter's tape marks possible knob positions
Added ago
The pins on the drawer front are trimmed flush with the sides
Added ago
After a few coats of finish
Added ago
Drawer fronts are finished with an oil/varnish blend, sides are... more
Added ago
Done and in the room! The grain in the drawer fronts is continuous... more
Added ago
The pale yellow/pink of the Douglas Fir goes really well with the... more
Added ago
The top ended up with some beautiful grain
Added ago